Invisiware® Threaded Tab

Here's a real time and money-saver. The Invisiware ® threaded tab screws into a drilled and tapped hole on the inside wall of the end post for mounting an Adjust-A-Jaw® or Adjust-A-Body® tensioner, Ultra-tec® Fixed Jaw, or Push-Lock™ fitting with threaded eye. You save the expense of welding tees or tabs onto your end post.

Recommended only when you are using a minimum schedule 80 pipe end post or a square or rectangular steel end post with a minimum .250' wall.

Invisiware® Extended Length Threaded Tab

Extended length, same as above except there is no need to thread the hole in your end post. Cut to desired length and secure to end post with acorn nut and thread sealant.

Invisiware® Fixed Tab

Welded into an end post to make a strong tab for use in mounting an Adjust-A-Jaw® or Adjust-A-Body® tensioner, Ultra-tec® Fixed Jaw, or Push-Lock™ fitting with threaded eye.

The Invisiware® fixed tab is cut to length if necessary, inserted in a hold drilled through the post and welded to the outside wall. The welded surface is then ground to the original contour of the post, thus hiding the weld.

Ultra-tec® Lag Eye

A convenient, easy-to-install means for attaching an Adjust-A-Jaw ® or Adjust-A-Body® tensioner, Ultra-tec® Fixed Jaw, or Push-Lock ™ fitting with threaded eye to a wood post.

Invisiware® Welded Receiver

A fixed end, non-tensioning device, the Invisiware® welded receiver provides a sturdy, threaded receptacle in the end post for an Invisiware® swaging stud.

The Invisiware ® welded receiver is cut to length if necessary, inserted in a hole drilled through the pos and welded to the outside wall. The welded surface is then ground to the original contour of the post, thus hiding the weld.

Mounting Screws

Stainless steel socket-head screws for mounting Adjust-A-Jaw® and Adjust-A-Body® with Threaded Eye tensioners, Ultra-tec ® Fixed Jaws, or Push-Lock™ fittings with threaded eye.

Stainless Steel Washers and Nuts

Cable Grommets

Cable grommets are offered for popular cable diameters of 1/8", 3/16" and 1/4". They help prevent rust in exterior applications or elsewhere where moisture is a factor, by providing a barrier between the cable and the painted or powder-coated surface through which the cable is drawn when being installed.

Ultra-tec® cable grommets are installed (after the paint or powder coating is applied) into holes in intermediate posts, cable braces and, in the case of the Invisiware® radius ferrule, Push-Lock™, and Pull-Lock™ fittings into the end post holes through which the cable exits. They are offered in black UV resistant Delrin®.